I live in Hungary and I bought the fork from Germany. However I have original invoice (from austrian offline shop) for the fork, I don't know how much warranty has remain...
I wouldn't be happy to buy a complete lower just becouse the bushimgs are fail. I changed oil and inspected the bushings...
Hi!
I'm kinda lost in the world of the internet by found a lot of irrelevant information...
I recently buy a used 888 CR 2012 and it has a lot of play by the bushes (the left side is more worn). I could find any information about these newer models only the 2008 series were bad becouse of...
I can't see how is that possible to use offset bushings on this frame, since the wallthickness of the axle is 1,35mm which goes through the eyelet...
However I realy don't like original design of the stock/original mount hardware. It wares out the frames connecting faces, since that 1,35mm of...
thanks the input, than I will do it.
It's already sandblasted. the surface looks like this (quite rough):
I left in the worn bearings in order to save the connecting surfaces of the bearing seats. works quite good. I washed out the grease so powdercoat won't "contaminate" the bores.
hi!
I'm up to have my frame powdercoated. It's after the sandblasting and I'm wondering if it is worth the effort to remove some material from the middle section of the frame. Is there any downside?
like this:
nice!
do you have any drawing of this headset?
does it use a standard bearingset as the original e.13?
I think the large sunday is the perfect cheap "modern" dh frame, if you could slacken the HA angle.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.