I seem to have a problem with my new 40, anyone else having the same issue, or anyone have any suggestions. I set the sag @ 50 psi and set the fork legs in the crowns with about 1/2" stick above the top crown last week. I changed a headset bearings tonight, set the height again, and checked the travel, only getting about 7-1/4" and almost an 1" is negative. I can hold the arch and the wheel and fully extend it. If I add more air it extends further. I took all the air out compressed it all the way, fork is set at the right spot as i have about 1/4 inch left on the stantions before they would bottom out. Filled with air, same deal, at 50 psi which allowed the right sag for me I'm not getting full extension, increase air and more of the fork comes out of the lowers, it's around 80 psi that i get the whole fork out. Anyone have any thoughts??