[J]

How do you take off the casset body of the Razor Rock rear hub? So far I have the casset off as well as that metal ring that is secured by the two 2mm screws. I can't see any other parts to loosen and the casset body isn't budging, do I just need to pull harder or am I missing something? Thanks.

-J

 

[J]

you need the RRR tool. Good luck.

Hows the Razor Rock tool work? Whats it do? I can probably fashion up something that would work...

-J

 

[J]

Searched with no picture results, however I did read to find out that the tool is used to adjust the hub on the drive side. I assume this is the metal ring I talked about before. I was able to get that ring off with a spanner. What is the next step/ piece to take off? I cannot see any places a tool would grab. I'm thinking that my hub is just too tight and the freehub needs some pulling.

I know RRR is out of buisness but you can stop acting like theres no hope.

-J

 

[J]

Where does the tool insert?

-J

 

[J]

Thanks for the info, I'm in the South Bay.

-J

 

[DrewS]

its all pressed together...i just pounded it out with a socket and a hammer from the non-drive side.