2010/11 Marzocchi 66 RC3 Ti oil levels
- Thread starter RayB
- Start date
335 cc left, 80 cc right
Thanks guys! Looking at the Marzocchi site sober is a lot easier as I found out this morning... turns out you have to create a login before getting access to the relevant info.
Anyways... did an oil change (along with a full tear-down) today and 335cc is a bit too much in the RC3 leg. I removed the spring and cycled the damper and with 335cc, the fork does not get full travel. (about 1.5" left when it hydro-lock's...)
I found out that around 275-290cc is the ticket. Hope this helps somebody out there...
Anyways... did an oil change (along with a full tear-down) today and 335cc is a bit too much in the RC3 leg. I removed the spring and cycled the damper and with 335cc, the fork does not get full travel. (about 1.5" left when it hydro-lock's...)
I found out that around 275-290cc is the ticket. Hope this helps somebody out there...
you dont have to create a login. its under "tech area" like in the link 6thelement posted.
odd that you are getting hydrolock with the suggested oil amounts since their 888 info is correct.
FYI: i changed my oil on said 2010 66 RC3 Ti a few months ago with Marzocchi specified oil levels and get full travel.
u sure u cycled the damper enough to get all the old oil out?
Bet you still had old fluid in there. When this could be the case, always measure from the top with the stanchion bottomed out and the damper fully extended. Unfortunately I don't know what that measurement would be.
