I'm getting a used Sunday in the mail in the next few days and I'd like to throw the existing CC angleset I already have in it to slacken it out.
I currently only have two .5 degree cups (top and bottom) for my angleset along with some 0degree cups. However, I am curious might it be possible to order two 1 degree cups and place one on both the top and bottom side of the headtube and get 2 degrees instead of one? If so, how might this affect bearing life? Will I be at risk with gimble popping? I've had this HS in my Jamis Komodo AM HT which I do lots of jumping, bumping and thumping on and have had none of the normally mentioned problems with the Angleset. But then again, I was VERY careful to install it properly (lines, rules and string).
Sorry if this question has been asked a million times over, I searched, but did not see an answer on the interwebs.
PS:This will be my first DH bike and I'm quite excited.
I currently only have two .5 degree cups (top and bottom) for my angleset along with some 0degree cups. However, I am curious might it be possible to order two 1 degree cups and place one on both the top and bottom side of the headtube and get 2 degrees instead of one? If so, how might this affect bearing life? Will I be at risk with gimble popping? I've had this HS in my Jamis Komodo AM HT which I do lots of jumping, bumping and thumping on and have had none of the normally mentioned problems with the Angleset. But then again, I was VERY careful to install it properly (lines, rules and string).
Sorry if this question has been asked a million times over, I searched, but did not see an answer on the interwebs.
PS:This will be my first DH bike and I'm quite excited.