anyone else notice the tapered "vein" on the backside of the lowers? this. It goes from where the foam ring sits and past the bleed port. Could this be some sort of oil circulator that keeps the foam ring and bushing lubed? I remember someone mentioning this was something fox was working on for...
I would get the service kit that has the most shit. I would plan on an air spring rebuild along with that wiper seal & foam ring replacement. You should also do a damper bleed as well as inspect the bladder and damper piston seal, they leak and or ingest oil. Sometimes this makes the bladder...
I just put some Atomlab Pimplite 3" rise bars on my hardtail and they are made from 2014 T6 and they seem to be a little bit moar flexier than the FU40's I ran previously. Never broken a bar but I replace them every year or two.
would be interesting to to see how this bike handles with a dual crown fork and 29" DH tires. it even looks like 650b's would work with the flip chip in the high setting and lower travel shox.
what HAB said, and if you increase fork travel by 10mm your bb height and seatpost angle stay almost the same as pre-angleset geo. External lower cup like the Cane Creek unit solves this if you are going from an integrated cup. I have requested an external lower cup -2 degree angled headset from...
Step 1) Find a friendly cat
Step 2) Catnip
Step 3) Set it on your broken bone and get it purring
"Cats purr during both inhalation and exhalation with a consistent pattern and frequency between 25 and 150 Hertz. Various investigators have shown that sound frequencies in this range can...
I think Intense did that back in 2001 when they first began working with 5.10 making shoes and if my bong shed memory of that Dirt Mag issue serves me correct I believe they said the tires would roll really slow and pick up everything off the ground and eject it so bad they were denting tubes...
I've used self-vulcanizing silicone tape to make a band around my bottles, and it holds them tight.
Also works great for tidying up cables, finishing bar tape, etc.
I use ESI tape because it's cheap, works great and I can always find it at a local shop...
Last February I rolled up some 26" Velocity Blunt 35's (30mm internal width) ran them with 2.5WT Shorty's, 2.4 DHR2's and tried a 2.3 Shorty on the back for a while, even trimmed down an old 2.5 DHF for a faster rolling rear and they all worked great.
Have yet to try 2.6's and I'm not sure...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.