So I just got this fork off a guy. It's been working good but now I got a problem. First off the whole "PAR" air valve at the bottom of the leg and the "ATA" air valve at the top. Manual says to have the ATA psi at least 15psi lower then the PAR psi, if you get that. Anyway whatever psi I pump into the bottom when I go to fill up the ATA it's already at the amount I put into the PAR. I can't get it stiff whatever I do.
Also at the same time just today the travel seems to be getting lower by itself. Like I maxed the travel adjustment out so it should be around 6" but the fork looks like its only at 3" now.
Does anyone have one of these forks? How do you have it setup?
Also at the same time just today the travel seems to be getting lower by itself. Like I maxed the travel adjustment out so it should be around 6" but the fork looks like its only at 3" now.
Does anyone have one of these forks? How do you have it setup?