888 handlebar spacer
- Thread starter Kntr
- Start date
when I had my Shiver I swapped them back and forth never seemed to make a difference...D
It doesn't matter.... You can use them to fine tune your bar position...
Brian
Brian
It doesn't matter as they are there to fine tune your bar position. Thats why the both of them form an elipse(?).
The problem I had with them is I bottomed out the all four bolts before they were tight around my Answer Pro-taper bar. Everyone else I know runs the oversize bar so they don't use the spacers. I had to run two of the thicker spacers and longer bolts to make mine work.
The problem I had with them is I bottomed out the all four bolts before they were tight around my Answer Pro-taper bar. Everyone else I know runs the oversize bar so they don't use the spacers. I had to run two of the thicker spacers and longer bolts to make mine work.
I have a protaper with the shims using the integrated stem and have plenty of clearence for the bolts
Not sure about mine?
But I can tighten all four bolts down to the point where the upper "clamps" bottom out on the lower "stem" portion. Then I can still move my bars. Not easily, but If I can move them in my garage, it would be rediculous on the trail.
I used two of the thicker halves and it works fine, but I needed to run bolts about 1/4" longer.
But I can tighten all four bolts down to the point where the upper "clamps" bottom out on the lower "stem" portion. Then I can still move my bars. Not easily, but If I can move them in my garage, it would be rediculous on the trail.
I used two of the thicker halves and it works fine, but I needed to run bolts about 1/4" longer.
On my EA70 with the shims, the clamps are either touching or just about to if I tighten them enough so that the bars don't spin.