Just built up a small 951 tonight and have somewhat of an issue. I used 165mm saint cranks and spaced the 83mm BB correctly with 2 spacers on drive side and 1 on non drive side.
The issue is the non-drove crank arm comes within what I would all 1/8" from the top of the rear chain stays. I would think this will be an issue as the cranks will flex and rub against the top chainstays
Its strange since I tried searching and only find info that this issue exists with the e13 cranks nothing with the saints. I ran this same setup with 170mm saints on a previous small frame without issue
The issue is the non-drove crank arm comes within what I would all 1/8" from the top of the rear chain stays. I would think this will be an issue as the cranks will flex and rub against the top chainstays
Its strange since I tried searching and only find info that this issue exists with the e13 cranks nothing with the saints. I ran this same setup with 170mm saints on a previous small frame without issue
Attachments
-
105.4 KB Views: 357
-
107.5 KB Views: 362