i need help. i am pretty handy when it comes to bike stuff but these blessed things have me on the edge.
i am having problems with the spacers that azonic sent to me... If i get the chaing line where i need it- the cranks will bind after a bit- if i use the spacers my chain line is crap. Any suggestions with what spacers you put where woudl be greatly appreciated. I am getting ready for Snowshoe and i would like this fixed asap. ( and getting new cranks is not an option __ HA HA )
the second issue I am having is that the spider is held inplace by 1 bolt. this is a very poor design in my optinion.. I have found that if i smack somthing hard enough it throws the spider out of true and then the bash ring hits on the guide hence a non spinning crank. Has anyone tried to place a bigger spacer in the spider to help stop this?
Fee free to email your thoughts or post a reply
karpieldisco@comcast.net
Just an fyi - This issue is so frustrating that i emailed Jan at Karpiel for his assistance..
i am having problems with the spacers that azonic sent to me... If i get the chaing line where i need it- the cranks will bind after a bit- if i use the spacers my chain line is crap. Any suggestions with what spacers you put where woudl be greatly appreciated. I am getting ready for Snowshoe and i would like this fixed asap. ( and getting new cranks is not an option __ HA HA )
the second issue I am having is that the spider is held inplace by 1 bolt. this is a very poor design in my optinion.. I have found that if i smack somthing hard enough it throws the spider out of true and then the bash ring hits on the guide hence a non spinning crank. Has anyone tried to place a bigger spacer in the spider to help stop this?
Fee free to email your thoughts or post a reply
karpieldisco@comcast.net
Just an fyi - This issue is so frustrating that i emailed Jan at Karpiel for his assistance..