[oly]

Mine are beyond worn, but i havent been able to contact anyone at azonic to find out the thread, or take the pins down to a scre shop to get a replacement. Was hoping to get the screw specs so i can call around,.... ANYONE?

thanks

 

[RD]

M4 x 0.7mm www.mcmaster.com part# 92029A144

That is for the 8mm stock set screws, go 10mm length if you want more grip. These are 316 stainless too, you can save some money if you go 18-8.

Ricky

 

[bradical]

I just looked around until i found a screw that fit, screwed it in and then cut it with a dremel. My homemade ones grip better than stock for some reason.

 

[oly]

M4 x 0.7mm www.mcmaster.com part# 92029A144

That is for the 8mm stock set screws, go 10mm length if you want more grip. These are 316 stainless too, you can save some money if you go 18-8.

Ricky

Thanks for the tip. I was having the machine shop guys i work with dig through their stuff, but they didnt have anything that small in metric.

Dont need more grip since i got a set of 510 shoes... but i need to replace the 10 pins that are missing, and the 5 pins that are ground to nothing......

Ill order some up using my company's account....

 

[Spunger]

100 of the others for $12 is a deal! They rape you on those stupid pins everywhere. I end up breaking them anyways so it doesn't matter. I'd rather throw $12 for 100 then $8 for 25 if you know what I mean.

 

[J5ive]

What do you guys do for ripped out pins where half the thread is gone?