alright here is the deal. brad sent me out a sun ringle 4 stroke bmx hub, which btw is amazing and feels as if it has as much engagement as my hadley's. it runs on a 3/8 inch axel with a built in 14mm adapter on one side and then a slide on adapter on the other side then an array of bolts and spacers. i managed to gheto rig it so that i can run a peg on one side but this leaves no room for chain tensioners. i need to figure out a way, either by running a 3/8 axel with 14mm adapters (that have to be long enough for pegs and tensioners) or runing a 3/8 axel with eastern 14mm adpter nuts meant for pegs (waiting to hear back from them atm) let me know your thoughts and ideas. weight is important too so hollow or ti stuff if welcome and encouraged