[wysiwyg]

Charger by wysiwyg_photography, on Flickr

Far left, not mentioned in instructions or video. I assume the oring goes inside the comp cap.

Anyone?

 

[cowman]

Charger by wysiwyg_photography, on Flickr

Far left, not mentioned in instructions or video. I assume the oring goes inside the comp cap.

Anyone?

I don't know for sure, but it looks like a compression/crush washer that goes between the nut that threads onto the bottom of the damper and the lowers.

 

[ChrisKring]

I didn't know either. Didn't install it. Seems to work fine without it but i don't like not knowing where it should be.

 

[tacubaya]

That's a wiper for the "base plate" (its actually a secondary sealhead), if you don't install it then why bother having a base plate installed, it isn't doing anything.

The kit came with two o-rings, one goes in the outside of the base plate, the other one in the top of the damper.

 

[wysiwyg]

They could mention this in some media of some sort. So the oring goes on the damper before it's installed? Already got other oring on the base plate. So where's the do hicky go again?

 

[tacubaya]

One o-ring seals the interface between the base plate and the stanchion. The other o-ring seals the interface between the damper and the stanchion (it goes in a gland above the threads of the damper).

 

[wysiwyg]

Check. So the other lipped piece on the left goes...

 

[wysiwyg]

Still can't work out where this wiper seal goes...

 

[tacubaya]

Still can't work out where this wiper seal goes...

Inside the base plate..

 

[wysiwyg]

Ah I see there's an indent inside. These instructions are tripe. Thanks a lot

 

[Chris_S]

The instructions arn't the best, which is odd given the full manual is pretty good.

Page 22 for the wiper seal
https://www.sram.com/sites/default/files/techdocs/gen.0000000004665_rev_a_2015_boxxer_team.pdf


Charger damper is all fitted up, not had a chance to ride them properly yet. All for less adjustments though