1* steeper 4mm shorter
I made them from 7075, because the rear lower cup is pretty thin.
Last edited:
Custom Angle and reach headset
- Thread starter englertracing
- Start date
1* steeper 4mm shorter
I made them from 7075, because the rear lower cup is pretty thin.
What are you fitting them to?
They are for my mondraker.
Slack as a chopper, I've already got a -1 in it.
The -4mm reach is because it turns like a barge
Last edited:
Even though its only -4 it does have a shorter feel now,
Which is exactly what I wanted...
The front wheel was too far out couldn't always here what it wanted to tell me
And weighting it meant drastic shift forward from the neutral position. We will see if its worth it....
Which is exactly what I wanted...
The front wheel was too far out couldn't always here what it wanted to tell me
And weighting it meant drastic shift forward from the neutral position. We will see if its worth it....
Neato
Very cool! Can we see your lathe and mill?
Would end up with something like -10mm wouldn't you with the steeper HA?
Just found this - that's SPECTACULAR!
Oh thanks.
I made a 1* slacker -5mm reach for my propain spindrift. 7075
And a shock clevice to go from 222x70 to 230x70
Last edited: