ran across these sprockets last nite and was wondering if anyone has had success running them on Profile cranks (19mm). i would think some modification would be required b/c of the built in spacer, but just curious if anyone has tried.
If you have access to a lathe, you could make a spacer really easily. A typical hat spacer or stock one would probably not work too well. You would want one as thick as the sprocket + the 8mm built in spacer.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.