[fireman]

Does any know if it is possible to run a Evil SRS on a Foes DHS, I'm running a MRP on it now but don't like it all that much. I know I could just run the evil supercharger instead of the MRP plates, but it doesn't seem like it would work as well as the full on evil. My guess from looking at my bike is that it isn't possible but I would love to hear otherwise.
thanks
zak

 

[Fulton]

saw one at northstar this year in line for the lift, looked like the guy cut the top half of the boomerang off, and mounted the plastic piece of the e13 guide to the stud that heald the mrp roller.

 

[DH Diva]

I have seen several that did work. Probably depends somewhat on the year as there have been several different chainguide mounting systems on the DHS over the years. Freak had a guy on his racing team that ran an evil on an '02 or '03 Mono and it worked great. Keep trying, I'm sure there's a way!

 

[Acadian]

saw one at northstar this year in line for the lift, looked like the guy cut the top half of the boomerang off, and mounted the plastic piece of the e13 guide to the stud that heald the mrp roller.

might of been 1soulrider?

 

[Fulton]

might of been 1soulrider?

that a good possibility. I'm sure I've seen lots of monkey's and not even known it!

 

[1soulrider]

Well, I should speak up here....
I have an 03 Mono and I run the Foes upper and lower rollers ( no other choice really)
with an MRP inner plate and E13 'supercharger' outer plate. I use a 38t ring w/ a slalom MRP plate & a urban size E13 bash guard. The E13 guard is just a little taller than the MRP plate so you can slid over rocks etc. w/o hanging up on the aluminum MRP. The difference in height is not enough that the rollers can't contain the chain. I have ran this setup for a year w/o any complaints. I also use a 128mm bb spindle to keep the chainline clean, this seems to work well w/ 165 mm rear hub.

 

[fireman]

Thanks for the input sounds like it's possible. I like your setup 1soulrider.
I have an 01' tube.
thanks
zak

 

[ssaddict]

Thanks for the input sounds like it's possible. I like your setup 1soulrider.
I have an 01' tube.
thanks
zak

Do you have an upper roller that bolts to the frame or use the whole MRP system with full boomerang?

Depending on clearance you may beable to run the whole system (e13), but those swingarms were big and came down alot. It may not allow you to rotate it back far enough for good clearance.

 

[fireman]

My DHS uses the Upper roller that bolts to the frame and a lower roller similar to an LRP roller. I'm pretty sure that I can't use a full evil guide with out a few BB spacers.
Evil emailed me back saying that they didn't have any ideas (besides 1soulrider's set up) and that it probably wouldn't fit.
zak