[MikeT]

so I got a stiff spring for my psylo xc(02), and I decided to put 10wt oil in as well... Well I put 20cc in the u-turn leg, and around... 140cc in the rebound leg(my syringe markings were mest-up so it was hard to tell exact cc's)... Now the fork feels alot stiffer, which is good, but it also now feels really harsh when I pull the wheel off the ground to wheelie or to drop... is this normal? because it was not harsh at all before... how do I know I put too much oil in? or too little ?

-Mike T.

 

[ohio]

I can't think of how changing the oil would effect top out. Did you mess with the spring stacks and preload at all?

Try dialing in a little more rebound... That's all I can think of.

Do you get it only in the full travel setting or with the U-turn set anywhere?

 

[MikeT]

full travel, I only changed the u-turn spring to firm. and its a whole stack, its not really in parts... so that cant be the problem, I'll get a measuring beaker with cc's and try measuring the oil again...

-Mike T

 

[WTGPhoben]

too little oil might be the problem... if the cartridge sucks air at the end it'll top out real hard.

 

[MikeT]

yea ur probebly right, I will try adding more oil

thanx

-Mike T