[ianjenn]

Ok this bike is now 99% done. I just wanted to see who has used the problem solver axle in an M1 and gotten it to work with a Saint derailleur?

If so can you explain how you got the drive side slot in the Saint into the frame tight enough?

Pics would be great!

 

[jvnixon]

Have you tried shimming the problem solver axle (adding shims to the non drive side)?

 

[iRider]

Moar........

 

[ianjenn]

Have you tried shimming the problem solver axle (adding shims to the non drive side)?

I was hoping I was missing a part. Basically the tab on the back of the saint is to thin to fit snug in the frame!

So I may have to go another route...

If not I may be able to use a shim or two to tighten it up.

 

[Eastern States Cup]

Jason said shimz

 

[daisycutter]

I am running a problem solver axle in an M1 with a Saint derailleur. It bolted right on. Do you have a horizontal drop out saint derailleur?

 

[ianjenn]

I am running a problem solver axle in an M1 with a Saint derailleur. It bolted right on. Do you have a horizontal drop out saint derailleur?

Its the M800 variety. Don t have the box here with me. So I am not 100% sure it is horizontal.

Did you use the QR Intense adapter on the rear dropouts or just the 12mm as is?

 

[daisycutter]

I was wrong, sorry. I took my rear axel off and realized I did dremal the provided washer down to fit.

 

[ianjenn]

I was wrong, sorry. I took my rear axel off and realized I did dremal the provided washer down to fit.

Ok I went with an LX for now and may adapt the Saint with some dremel time. Thanks for checking!