[bullcrew]

So playing around with the m9, measured the 40 and it will handle a 29 tire with 5mm at complete compression...

Figured I have parts, time and curiousity..

I already run it in longest rear setting with 26" wheel and like the way it handled...
Already ran mullet 27.5/26 so it'll be the same just. A smidge higher..once I modify a hole it'll be lower which at 14.2 isn't a deal killer for me...

Bb 14.2 (can modify a hole to drop it .5)
Stock is 13.8 to 14.2

Wheelbase is 49.5

Ha not sure I can move it around with a Angleset anywase but I like how it rides. I'll check it later.

Anyhow gonna build a 29" wheel up and see how it hits the nasty and corners...

 

[fwp]

So playing around with the m9, measured the 40 and it will handle a 29 tire with 5mm at complete compression...

Figured I have parts, time and curiousity..

I already run it in longest rear setting with 26" wheel and like the way it handled...
Already ran mullet 27.5/26 so it'll be the same just. A smidge higher..once I modify a hole it'll be lower which at 14.2 isn't a deal killer for me...

Bb 14.2 (can modify a hole to drop it .5)
Stock is 13.8 to 14.2

Wheelbase is 49.5

Ha not sure I can move it around with a Angleset anywase but I like how it rides. I'll check it later.

Anyhow gonna build a 29" wheel up and see how it hits the nasty and corners...View attachment 163770View attachment 163771

If its compatible try a 2 degree works angleset, should drop your bb considerably, dropped mine from 13.6 to under 13. So much so I had to take it out it was to low for me.

 

[bullcrew]

If its compatible try a 2 degree works angleset, should drop your bb considerably, dropped mine from 13.6 to under 13. So much so I had to take it out it was to low for me.

Yeah I will see where I'm at angle wise and that is definitely an option...thanks