Does anyone have instructions on how to lower a fox float 36 rc2 or diagram? Looking to lower it to 80mm or 90mm
lowering a fox float 36 rc2
- Thread starter quickneonrt
- Start date
THere are rebuild/tech instructions and pictures on the fox site.
To lower the float as well as just about any single chamber air fork, you simply need to put a spacer under the air piston (where the top-out spring is) of the length that you want the fork lowered.
To lower the float as well as just about any single chamber air fork, you simply need to put a spacer under the air piston (where the top-out spring is) of the length that you want the fork lowered.
Thanks I will check the site and call Fox Monday for spacers.
Or you can drill it. Either way works.
You will need a few 20mm spacers one new compression washer, at least a pillow pack of float fluid and 7wt fork oil before you start.
The job is pretty straight forward, since you only have to take the disc side apart.
The job is pretty straight forward, since you only have to take the disc side apart.
Ah all I have is 7.5wt oil. I guess I can get what I need through fox. I know I can order the spacers and crush washer from them.
drill what?
Wow,..blast from the past.