[Scurry]

Were can I get another one of the bolts for a 2003 IH sgs pro. The actual axle is stripped. (see pic)

Also what rate spring do people with sgs's use, I weigh 160 and have a 500 lb spring, I think it's a bit much, would a 400 work better?

 

[dw]

You can use one of these grade 12.9 M8 bolts and it will work perfectly. The length that you need is really only 90mm, but I suggest using a 100mm bolt and cutting it down by 8mm or so. That way you get more bolt shank and less thread. 9$ for a pack of 10.

A 400 or 450 spring would be a lot better. Depending on your skill level and if you are racing only, you could even pull off 350, but only if you are pretty smooth.

Dave


www.mcmaster.com

91303A225
(Same as 91303A900)
Metric Blue Coated Socket Head Cap Screw M8 Thread, 100mm Length, 1.25mm Pitch
In stock at $8.98 per Pack
This item is only sold in Packs of 10

 

[Scurry]

You can use one of these grade 12.9 M8 bolts and it will work perfectly. The length that you need is really only 90mm, but I suggest using a 100mm bolt and cutting it down by 8mm or so. That way you get more bolt shank and less thread. 9$ for a pack of 10.

A 400 or 450 spring would be a lot better. Depending on your skill level and if you are racing only, you could even pull off 350, but only if you are pretty smooth.

Dave


www.mcmaster.com

91303A225
(Same as 91303A900)
Metric Blue Coated Socket Head Cap Screw M8 Thread, 100mm Length, 1.25mm Pitch
In stock at $8.98 per Pack
This item is only sold in Packs of 10

Thanks a lot, Ill probly go with a 400, race Jr X but not that smooth, so ill give that a shot. Any one know a good online place to order one through, i'll probly just go through my lbs but that might not work.

 

[Kntr]

Go-Ride and get a Ti spring