So the manual says that the four allen axel bolts should be 5mm @ 10nm torque... but the four allen bolts i have are 4mm wtf?? so whats the torque spec???
10nm is too much. using the 1-2-1 tightening method, the first bolt goes ok, then the other side just clamps right down (closes the gap completely) , so i dont wanna go to 10nm and chance stripping it....
help me out here....
thx
phil
10nm is too much. using the 1-2-1 tightening method, the first bolt goes ok, then the other side just clamps right down (closes the gap completely) , so i dont wanna go to 10nm and chance stripping it....
help me out here....
thx
phil
