Hi there,
Just found out that my main pivot point is loose, the whole bearings can move inside their slots. The play is about 0.1mm and slots are a little ovalized. What can i do about it ?
Shall i put a locktite 609 in there ? However bearings used are crap and get busted quickly( I run a 3rd set of them and its loose as well), what it they get loose again?
I was working really hard to get that frame and now after 2months its dump, thats why I am really annoyed, sorry for that.
Regards
Edit:
Forgot to tell, its 2006 model.
Just found out that my main pivot point is loose, the whole bearings can move inside their slots. The play is about 0.1mm and slots are a little ovalized. What can i do about it ?
Shall i put a locktite 609 in there ? However bearings used are crap and get busted quickly( I run a 3rd set of them and its loose as well), what it they get loose again?
I was working really hard to get that frame and now after 2months its dump, thats why I am really annoyed, sorry for that.
Regards
Edit:
Forgot to tell, its 2006 model.