I am trying to remove the main pivot from the 4X and it won't budge at all.
I went with along with the instructions in the manual from Yeti. I loosed the small non drive side bolt and tried to drive the main pin from the drivers side to the non drivers side. I also tried the other way to make sure that I wasn't going the wrong way. I tried loosing it up with an allen wrench on the non drive side and it barely budges, takes a lot of force to spin it.
Am I doing something wrong here? I also loosened up the pinch bolts on the bearing with no luck either.
I need to get this finished monday afternoon as I plan on leaving for rays for a mid january ride session.
Any Help would be much appreciated.
I went with along with the instructions in the manual from Yeti. I loosed the small non drive side bolt and tried to drive the main pin from the drivers side to the non drivers side. I also tried the other way to make sure that I wasn't going the wrong way. I tried loosing it up with an allen wrench on the non drive side and it barely budges, takes a lot of force to spin it.
Am I doing something wrong here? I also loosened up the pinch bolts on the bearing with no luck either.
I need to get this finished monday afternoon as I plan on leaving for rays for a mid january ride session.
Any Help would be much appreciated.