The ending stroke rebound knob on my boxxer spins without limits. I have taken the rebound assembly out for a look, but I need some more info from someone in the know.
The beginning stroke rebound adjustment works fine - I can see the needle move up and down through the 4 ports in the middle of the photo. When I move the end stroke adjuster though, not much happens (though I can see the needle rotating). There is no visible damage to anything through the ports.
Any ideas? What should happen when the end stroke rebound is adjusted? Should I take the rebound assembly apart to investigate and if so how?
PS: It's not a problem with the adjusters itself, I have checked them
![_MG_4432.jpg](/data/attachments/25/25268-ffc6f3de3dce7793b9ace5e420c6a4c6.jpg)
The beginning stroke rebound adjustment works fine - I can see the needle move up and down through the 4 ports in the middle of the photo. When I move the end stroke adjuster though, not much happens (though I can see the needle rotating). There is no visible damage to anything through the ports.
Any ideas? What should happen when the end stroke rebound is adjusted? Should I take the rebound assembly apart to investigate and if so how?
PS: It's not a problem with the adjusters itself, I have checked them
![_MG_4432.jpg](/data/attachments/25/25268-ffc6f3de3dce7793b9ace5e420c6a4c6.jpg)
Last edited: