So i've got my first sealed bearing headset (raceface diablous), and I'm about to install it. I've got access to a park headset press.
Only thing is I'm a little concerned about applying that much preasure on the bearings. I was given advice by a freind to take off all the shims on the headset press and press against the headset cup flanges. So is this how it's done? I'm a little skeptical.
Thanks
Only thing is I'm a little concerned about applying that much preasure on the bearings. I was given advice by a freind to take off all the shims on the headset press and press against the headset cup flanges. So is this how it's done? I'm a little skeptical.
Thanks