So yeah. Normally it's the bushings or something but right now I cannot figure it out. I just got my shock back from Elka and put it on and now there is a bit of play.
The only thing that may have done it is when I popped out the little black peice (2011 Shocker) so I could reroute the cable through there. Now when I did that I notcied the bearings were not aligned perfect and one happend to pop out when I was doing something....so I popped both of them out and put them back in by screwing the bolt in. Now they are not all the way in (they were not to start...they did not go all the way into the machined out spot...there is a spacer) but the spacer takes up the reaming space but now both are the same. But yeah that might have made no sense anyways...there is play that there was not before. In this image I am talking about where the shock mount connects to the downtube. This one has a solid peice..between the two shock mount plate thingssssssss.
The only thing that may have done it is when I popped out the little black peice (2011 Shocker) so I could reroute the cable through there. Now when I did that I notcied the bearings were not aligned perfect and one happend to pop out when I was doing something....so I popped both of them out and put them back in by screwing the bolt in. Now they are not all the way in (they were not to start...they did not go all the way into the machined out spot...there is a spacer) but the spacer takes up the reaming space but now both are the same. But yeah that might have made no sense anyways...there is play that there was not before. In this image I am talking about where the shock mount connects to the downtube. This one has a solid peice..between the two shock mount plate thingssssssss.