I'm working on a 2011 Boxxer R2C2. I slid on the lowers and when I get to installing the rebound damper shaft bolt it will thread in a few turns then stop and begin spinning the damper shaft.
Any suggestions on how I can get the damper shaft to stop spinning so the bolt will tighten? I've tried compressing the fork while tightening but it's not working.
any help appreaciated.
Any suggestions on how I can get the damper shaft to stop spinning so the bolt will tighten? I've tried compressing the fork while tightening but it's not working.
any help appreaciated.