I took off the rear wheel to clean the bike and I could not get it back proberly without the disk rubbing heavily (wheel barely moving) . I played with the axel and QR just to make sure it was all the way in and it was. It seems that when I put the wheel in the disk is in the center of the pads but when I hit the brake to center them the disk is always stuck on the inside pad.
Took the pad off and 1 of them is pretty unevenly worn. Could that be it. I put 1 more spacer to reallign the calliper and it was fine until I hit the brake and then again the disk was stuck on the pad?
I will buy new pads later on , anyone has any other suggestions?
Took the pad off and 1 of them is pretty unevenly worn. Could that be it. I put 1 more spacer to reallign the calliper and it was fine until I hit the brake and then again the disk was stuck on the pad?
I will buy new pads later on , anyone has any other suggestions?