Ok, I need a bit of help here. My cranks were creaking so I've taken them apart, wiped down the interface and put a bit of grease on.
Put it all back together (I hope the right way!) but I can't seem to locate the bolt-on chainring quite right - the chain will be pulled completely taut at one point and totally slack 180 degrees later in the rotation. Is there a simple way to adjust the positioning to ensure an even tension throughout a rotation?
Put it all back together (I hope the right way!) but I can't seem to locate the bolt-on chainring quite right - the chain will be pulled completely taut at one point and totally slack 180 degrees later in the rotation. Is there a simple way to adjust the positioning to ensure an even tension throughout a rotation?