ive seen steel thru axles come stock with several generic taiwan hubs, novatec, gusset, kore, etc, etc.
theyre normally just a plain axle with nuts on both sides
the guy in the picture has also been known to produce such axles, although on the picture he is showing a shock rebound adjuster knob he just made by grafting a bronze end piece to the original alloy adjuster part.
Easy enough to make an axle. I run one I zipped up.
12mm barstock, step the ends down to 10mm, and then thread them.
Talk to somebody at a machine shop.
Easy enough to make an axle. I run one I zipped up.
12mm barstock, step the ends down to 10mm, and then thread them.
Talk to somebody at a machine shop.
I made one my self from a bike kickstand, i had to sand it down a little bit then it fitted like a glove. Ill cutted it so it was like 5 mm shorter than framewidth then i drilled 6 mm holes in each end, made M7 threads and then just thow in the M7 bolts with blue locktite.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.