BMX grips = MTB grips
- Thread starter buildyourown
- Start date
BTI lists mountain and bmx grips together and I pulled up ODI and under some of the BMX grips its says takes standard mtb/bmx lock-on clamps. I think most BMX grips a just a little bit longer since there is less to put on the bar.
Sweet. I noticed that they sell that grip in a 130mm and a 143mm length. 130mm is standard mtb.
bmx grips blow most mtn bike grips out of the water.
These are my favorite:
I run my brakes fairly inboard, so the long 143mm length is perfect.
Just needs a little trimming of the flange for the trigger shifter.
I run my brakes fairly inboard, so the long 143mm length is perfect.
Just needs a little trimming of the flange for the trigger shifter.
with very few exceptions most grips are for bars 7/8" OD.
If you're looking for grips with flanges, DMR and Deity do grips with them. They're(the flanges) also smaller than regular BMX grips, so you don't have to trim them down to get them to work without getting in the way of your shifters and such. I'm running Deity's Enoki grips on my bike.
I think I have the grips you linked to. They fit fine.
They have the same inner diameter, they are designed for bars with a 22.2 mm OD.