I have two questions about rotors. For XC riding is there a big difference in the performance of the 160 versus 180 mm rotors? Again, for XC use, are the aluminum rotors worth the extra money?
For the ultimate light set up remove your brakes. You don't need brakes to control your speed on a climb.
Seriously, 160mm is more than enough for XC use.
As for Al rotors, if they get bent you will have a tough time truing them and they will be much weaker. Also if you're looking to shed grams the hub area has very little rotational inertia. Look at your rims/tires and tubes for weight savings.
I also heard Lance Armstrong had surgery to remove all unnesessary body parts to save weight. Only one kidney, spleen has been shaved down, all of his toes are removed, only one testicle and all of his ligaments have been cut in half lengthwise.
You could just undergo chemotherepy to get the body mass down. Hey, it worked for Lance.
i think the only time that big rotors help is on epic descents (XC/Trail). There are tons of XC trails here where after climbing up the mountain you have to stop periodically on the downhill to cool the rotors or you get serious "fade". Bigger rotors have more area to cool so they resist that a tad better, that's all.
Summer i'm constantly on rides where you ride down thousands of feet, cross a creek and hear the steam rise off of the rotors. And i still run 6'ers on my XC bike.
i think the only time that big rotors help is on epic descents (XC/Trail). There are tons of XC trails here where after climbing up the mountain you have to stop periodically on the downhill to cool the rotors or you get serious "fade". Bigger rotors have more area to cool so they resist that a tad better, that's all.
Summer i'm constantly on rides where you ride down thousands of feet, cross a creek and hear the steam rise off of the rotors. And i still run 6'ers on my XC bike.
Summer i'm constantly on rides where you ride down thousands of feet, cross a creek and hear the steam rise off of the rotors. And i still run 6'ers on my XC bike.
i know, i've been jonesin for some grueling climbs and long epic descents, but we had one hell of a snowy winter. No highlander action for me in early spring, it's gonna be awhile before the snow melts off the high trails this year.
I looked at the Al disc info at Stan's. Hundred beans a disc, whoa! You have to use minimally abrasive pads too. Hmm, is that an oxymoron there? Not recommended for riders over 150lbs. That counts me out. You could probably save the same amount of weight if you used Ti hardware. Like Peeete says, the inertia is so close to the hubs it wont really matter anyway. I'll just carry one less cliff bar.
i know, i've been jonesin for some grueling climbs and long epic descents, but we had one hell of a snowy winter. No highlander action for me in early spring, it's gonna be awhile before the snow melts off the high trails this year.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.