I have just pressed in my headset , FSA orbit MX all went in nice , straight and smooth with a dash of copper grease.
Now between the heatube and the cup is a gap very thin about 2 bits of paper.
But no matter how hard i wind the tool it does not go anymore l there is no lip in the headtube and the upper and lower cup have exactly the same issue?
Is this the headset? Is it the way these headsets sit in the frame or should it be tight to the headtube?
Just cant work it out.
Thanks for the advice in advance
Now between the heatube and the cup is a gap very thin about 2 bits of paper.
But no matter how hard i wind the tool it does not go anymore l there is no lip in the headtube and the upper and lower cup have exactly the same issue?
Is this the headset? Is it the way these headsets sit in the frame or should it be tight to the headtube?
Just cant work it out.
Thanks for the advice in advance