ive been looking around to see if anyone is running a similar set up and struggling, so thought id just ask the question.
frame is 73mm bb shell.
150mm rear end.
the idea is to run 1x9 or 1x10. it will be a hardtail, but with offset seat tube, so an iscg 05 mount would be preferable. cranks will be the xtr m980 triple. ideally the ring will be in the outer position to give good chainline for the 150 rear end.
am i likely to run into interference between the crank and the back plate? will removing the granny tabs be the way forward or am i looking at too little space altogether?
any advice on this appreciated.
frame is 73mm bb shell.
150mm rear end.
the idea is to run 1x9 or 1x10. it will be a hardtail, but with offset seat tube, so an iscg 05 mount would be preferable. cranks will be the xtr m980 triple. ideally the ring will be in the outer position to give good chainline for the 150 rear end.
am i likely to run into interference between the crank and the back plate? will removing the granny tabs be the way forward or am i looking at too little space altogether?
any advice on this appreciated.