I read through a bunch of old posts about adjusting my rear der. I tinkered around with it for about 30 minutes the other day and made some very noticable headway. I've got so that everythign is basically lined up over the smallest cog when in the highest gear, and lined up over the largest cog when in the lowest gear. My my stand, the bike shifts smoothly and quickly, just like it should. When I ride it, it shifts fine to and from the largest/smallest cogs, but seems to jump back and forth between mid-range cogs. It won't shift and stay in gear... instead the chain jumps between the cog I shifted to and the one I just came from.
Any tips on how I can fix this? Is it a cable tension thing? If I understand correctly, the limiting screws stop the der. from pusing the chain too far (off the cassette in either direction), and the barrel adjuster (the thing under the small rubber boot) lines up the pulleys/chain with the appropriate cog, correct?
Any tips would be helpful.
Any tips on how I can fix this? Is it a cable tension thing? If I understand correctly, the limiting screws stop the der. from pusing the chain too far (off the cassette in either direction), and the barrel adjuster (the thing under the small rubber boot) lines up the pulleys/chain with the appropriate cog, correct?
Any tips would be helpful.