Hard to describe, but on chattery stuff the fork feels like it's vibrating or just not operating smoothly or something.
I changed the air shaft on it from 170 down to 160mm.
I have about 85-90ish psi in it. Yes I'm fat. Running high speed compression open and 2 or 3 clicks of low speed.
I left the single air token in it, which it had from the factory.
Any thoughts? Did I perhaps put too much grease on the air shaft?
Also to note, when I changed the shaft, I wasn't able to do step 5 in the image below. When pulling the shaft out, it felt like it was pushing against a cushion of air. Just couldn't pull it out. Did I do something wrong?
Thoughts?
I changed the air shaft on it from 170 down to 160mm.
I have about 85-90ish psi in it. Yes I'm fat. Running high speed compression open and 2 or 3 clicks of low speed.
I left the single air token in it, which it had from the factory.
Any thoughts? Did I perhaps put too much grease on the air shaft?
Also to note, when I changed the shaft, I wasn't able to do step 5 in the image below. When pulling the shaft out, it felt like it was pushing against a cushion of air. Just couldn't pull it out. Did I do something wrong?
Thoughts?