Hi There
Having been noting but impressed with the level of performance from my SRS guide I have just bought a LG1 guide to go on my new Nomad. I have a set of RaceFace Atlas cranks and a 36 tooth DMR
I checked both e-13´s online guidepicker and their 2006 fitchart before buying the guide by mailorder.
When I mount everything up, quite a few problems accured:
Although I have put both spacers on the BB axel on the driveside (=50mm chainline) and have used no spacers at all on the guide, the teeth on the chainring is not centered in the two guides. They sit too far inward. I can´t move the chainguide further inward, and the driveside crank is spaced out as far as possible! I might add that I have used the mounting plate because the Nomad isn´t born with ISCG-05 tabs. And yes; the mounting plate is the right way on.
Has anyone else had problems with this setup? I have mailed E-13 about it, but they haven´t come up with a solution as of yet other than asking if everything was mountet correctly wich it is...
I can´t see a soultion that would not incorporate bending both arms of the guide, and quite frankly, I haven´t spend this much money on a chainguide just to manhandle it in this way to make it fit.
I hope that you can provide me with a solution, so that I do not have to be stuck with a guide that don´t fit. I am pretty sure I can´t return the guide, as it has been mounted already.
Regards, Emil
Having been noting but impressed with the level of performance from my SRS guide I have just bought a LG1 guide to go on my new Nomad. I have a set of RaceFace Atlas cranks and a 36 tooth DMR
I checked both e-13´s online guidepicker and their 2006 fitchart before buying the guide by mailorder.
When I mount everything up, quite a few problems accured:
Although I have put both spacers on the BB axel on the driveside (=50mm chainline) and have used no spacers at all on the guide, the teeth on the chainring is not centered in the two guides. They sit too far inward. I can´t move the chainguide further inward, and the driveside crank is spaced out as far as possible! I might add that I have used the mounting plate because the Nomad isn´t born with ISCG-05 tabs. And yes; the mounting plate is the right way on.
Has anyone else had problems with this setup? I have mailed E-13 about it, but they haven´t come up with a solution as of yet other than asking if everything was mountet correctly wich it is...
I can´t see a soultion that would not incorporate bending both arms of the guide, and quite frankly, I haven´t spend this much money on a chainguide just to manhandle it in this way to make it fit.
I hope that you can provide me with a solution, so that I do not have to be stuck with a guide that don´t fit. I am pretty sure I can´t return the guide, as it has been mounted already.
Regards, Emil