Does anyone know where I can get these types of pins?
How about the M4 bolts and washers?
How about the M4 bolts and washers?
Help sourcing hardware...pins...bolts
- Thread starter menachite
- Start date
I just PM'd CBJ...
Called McMaster before posting this...trust me I didn't want to waste anyones time...
They only have engrish sizes...no metric. Do you know something they don't know?
How about this?
http://www.unicorpinc.com/metric-standoffs.htm
Called McMaster before posting this...trust me I didn't want to waste anyones time...
They only have engrish sizes...no metric. Do you know something they don't know?
How about this?
http://www.unicorpinc.com/metric-standoffs.htm
Sweet...now I just need to cut it to length and thread the inside of it.
If mcmaster doesnt have it or cant get it I would try these next.
www.fullermetric.com
www.reidsupply.com
then
google
carr-lane
msc
james walker
www.fullermetric.com
www.reidsupply.com
then
carr-lane
msc
james walker
Just saw daveps post and theyve got a thread call out on there.
See my link above.........Misumi has TONS of material/length/thread/configuration combinations in their shafts....might save you the time of having to rework a shaft from somewhere else. Not too sure on the fillet at the ends though, as they are linear shafts and not pins. Could easily add one though.
Thank You Joe!
Yea, most available in 1mm lengths....wow! So much available it would take some time to figure it out.... I dont think he needs/wants the fillets. The end of the rod bottoms against the linkage/bell crank IIRC.
There something there that's going to work for you? I hope so......
There should be! Thanks again!
Anytime!