See my link above.........Misumi has TONS of material/length/thread/configuration combinations in their shafts....might save you the time of having to rework a shaft from somewhere else. Not too sure on the fillet at the ends though, as they are linear shafts and not pins. Could easily add one though.
See my link above.........Misumi has TONS of material/length/thread/configuration combinations in their shafts....might save you the time of having to rework a shaft from somewhere else. Not too sure on the fillet at the ends though, as they are linear shafts and not pins. Could easily add one though.
Yea, most available in 1mm lengths....wow! So much available it would take some time to figure it out.... I dont think he needs/wants the fillets. The end of the rod bottoms against the linkage/bell crank IIRC.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.