So i just got my new travis (as a backup fork ) and i noticed the a-c height is pretty monstorous. I was wondering if anyone knew off hand if they lower crown could be dropped a bit before I run into frame/arch "problems"
The arch shouldn't hit the frame before the tire hits the crown (when the lower crown is at it's lowest setting).
This MAY be different if you have a frame with an odd-design down-tube (like with a bulge before the headtube - I don't know of any) AND you're running a zero-stack headset.
I had the crown too low once and the tire buzzed the crown before it bottomed out but the arch didn't hit. I'm running an FSA Orbit-Z zerostack for a 1.5" headtube and Travis Ti 203mm (Michelin Comp32S and sometimes Minion DHF 2.5")
Which Travis is it?
its the 180 '06. And my headset set up is pretty tall right now, no zero-stack here. I guess ill give it a shot. 9 inches of exposed stanchions is just begging to be lowered.
its the 180 '06. And my headset set up is pretty tall right now, no zero-stack here. I guess ill give it a shot. 9 inches of exposed stanchions is just begging to be lowered.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.